Thermal flowmeter manufacturers suggest that insertion thermal probes be oriented so that condensation on the pipe walls cannot travel down the probe to the sensor.

Increasing flow from 100 to 200 liters per minute will cause an orifice plate primary flow element to generate what percentage of differential pressure?

An insertion thermal flowmeter was selected because it was linear and able to measure mass over a wide flow range of flows.

Given the much higher viscosity of chocolate, it is likely that at least a 3-inch Coriolis mass flowmeter will be needed.

How should weep holes and vent holes of an orifice plate be oriented in a vertical pipe?

The time it takes for people to recognize an error or oversight can be small or take decades.

The idea behind weep holes and vent holes is to remove the fluid in the nonflowing state from the flow measurement system.

It often takes an open mind and multiple experts to examine problems from different perspectives.

Knowing which approach is appropriate for the problem at hand is more an art rather than science.

The accuracy of a differential pressure measurement system includes the performance of the primary element and its transmitter.